build/patch/kernel/archive/imx6-5.13/0001-binding-doc-power-pwrseq-generic-add-binding-doc-for.patch

74 lines
2.4 KiB
Diff
Raw Normal View History

From f5528e96b7dd2b30e1accc518df85d14baad6bae Mon Sep 17 00:00:00 2001
From: Peter Chen <peter.chen@nxp.com>
Date: Thu, 18 May 2017 08:48:57 +0800
Subject: [PATCH 1/9] binding-doc: power: pwrseq-generic: add binding doc for
generic power sequence library
Add binding doc for generic power sequence library.
Signed-off-by: Peter Chen <peter.chen@nxp.com>
Acked-by: Philipp Zabel <p.zabel@pengutronix.de>
Acked-by: Rob Herring <robh@kernel.org>
---
.../bindings/power/pwrseq/pwrseq-generic.txt | 48 +++++++++++++++++++
1 file changed, 48 insertions(+)
create mode 100644 Documentation/devicetree/bindings/power/pwrseq/pwrseq-generic.txt
diff --git a/Documentation/devicetree/bindings/power/pwrseq/pwrseq-generic.txt b/Documentation/devicetree/bindings/power/pwrseq/pwrseq-generic.txt
new file mode 100644
index 000000000000..ebf0d477b688
--- /dev/null
+++ b/Documentation/devicetree/bindings/power/pwrseq/pwrseq-generic.txt
@@ -0,0 +1,48 @@
+The generic power sequence library
+
+Some hard-wired devices (eg USB/MMC) need to do power sequence before
+the device can be enumerated on the bus, the typical power sequence
+like: enable USB PHY clock, toggle reset pin, etc. But current
+Linux device driver lacks of such code to do it, it may cause some
+hard-wired devices works abnormal or can't be recognized by
+controller at all. The power sequence will be done before this device
+can be found at the bus.
+
+The power sequence properties is under the device node.
+
+Optional properties:
+- clocks: the input clocks for device.
+- reset-gpios: Should specify the GPIO for reset.
+- reset-duration-us: the duration in microsecond for assert reset signal.
+
+Below is the example of USB power sequence properties on USB device
+nodes which have two level USB hubs.
+
+&usbotg1 {
+ vbus-supply = <&reg_usb_otg1_vbus>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_usb_otg1_id>;
+ status = "okay";
+
+ #address-cells = <1>;
+ #size-cells = <0>;
+ genesys: hub@1 {
+ compatible = "usb5e3,608";
+ reg = <1>;
+
+ clocks = <&clks IMX6SX_CLK_CKO>;
+ reset-gpios = <&gpio4 5 GPIO_ACTIVE_LOW>; /* hub reset pin */
+ reset-duration-us = <10>;
+
+ #address-cells = <1>;
+ #size-cells = <0>;
+ asix: ethernet@1 {
+ compatible = "usbb95,1708";
+ reg = <1>;
+
+ clocks = <&clks IMX6SX_CLK_IPG>;
+ reset-gpios = <&gpio4 6 GPIO_ACTIVE_LOW>; /* ethernet_rst */
+ reset-duration-us = <15>;
+ };
+ };
+};
--
2.20.1