From eef011e438154edd25a002fbb77b017ba50e8423 Mon Sep 17 00:00:00 2001 From: =?UTF-8?q?Ond=C5=99ej=20Jirman?= Date: Thu, 12 Jan 2017 16:34:57 +0100 Subject: [PATCH 001/389] clk: sunxi-ng: Set maximum P and M factors to 1 for H3 pll-cpux clock When using M factor greater than 1 system is experiencing occasional lockups. P factor should only be used for clock speeds below 288MHz. We don't use such speeds in the mainline kernel. This change was verified to fix lockups with PLL stress tester available at https://xff.cz/git/arisc-firmware/. Note that M factor must not be used outside the kernel either, so for example u-boot needs a similar patch. Signed-off-by: Ondrej Jirman --- drivers/clk/sunxi-ng/ccu-sun8i-h3.c | 24 +++++++++++++++--------- 1 file changed, 15 insertions(+), 9 deletions(-) diff --git a/drivers/clk/sunxi-ng/ccu-sun8i-h3.c b/drivers/clk/sunxi-ng/ccu-sun8i-h3.c index d3fcb983c17c..3f97db379325 100644 --- a/drivers/clk/sunxi-ng/ccu-sun8i-h3.c +++ b/drivers/clk/sunxi-ng/ccu-sun8i-h3.c @@ -25,15 +25,21 @@ #include "ccu-sun8i-h3.h" -static SUNXI_CCU_NKMP_WITH_GATE_LOCK(pll_cpux_clk, "pll-cpux", - "osc24M", 0x000, - 8, 5, /* N */ - 4, 2, /* K */ - 0, 2, /* M */ - 16, 2, /* P */ - BIT(31), /* gate */ - BIT(28), /* lock */ - CLK_SET_RATE_UNGATE); +static struct ccu_nkmp pll_cpux_clk = { + .enable = BIT(31), + .lock = BIT(28), + .n = _SUNXI_CCU_MULT(8, 5), + .k = _SUNXI_CCU_MULT(4, 2), + .m = _SUNXI_CCU_DIV_MAX(0, 2, 1), + .p = _SUNXI_CCU_DIV_MAX(16, 2, 1), + .common = { + .reg = 0x000, + .hw.init = CLK_HW_INIT("pll-cpux", + "osc24M", + &ccu_nkmp_ops, + CLK_SET_RATE_UNGATE), + }, +}; /* * The Audio PLL is supposed to have 4 outputs: 3 fixed factors from -- 2.35.3